Can you match something that already exists?

Yes — an existing panel, a neighbouring property's detail, or a piece of the house itself.

Structural repair, not a new gate?

We weld on site. Posts, frames, hinges and rails get repaired where they stand.

Can you work from a photograph?

Yes. A photograph of the detail you want matched is usually more useful than a description of it.

Does custom mean a different scale of job?

Not necessarily. Where the opening is an odd width or the pier is not square, a made piece is often the only thing that fits at all.

Custom Gate Fabrication in Cutler Bay, FL

Angle grinder throwing a fan of sparks off a steel edge

Custom fabrication · Cutler Bay, FL

Drawn properly, then shown on your own entrance before a cut is made.

Get a quote

(954) 245-0182

Custom & Welding · Cutler Bay

05 frames

Fabricator welding an aluminum picket fence panel in place on site

Welded on site

Sparks falling in front of a metal fence panel being worked on — Sparks off the panel

Gilded heraldic crest mounted on an ornamental iron gate — Crest, gilded

Tall ornate iron gate with scrollwork between stone pillars and lanterns — Scrollwork and lanterns

Torch cutting through steel box section on a bench with sparks pouring off — Cutting the sections

Solar panel mounted above a white ornamental gate, with the operator box sitting at its foot. — The south corridor — Down US-1 toward the agricultural edge, where lots widen again and mains power is not a given.

Cutler Bay · Miami-Dade County

Most custom gates begin as something drawn badly on a phone. That is genuinely enough. It gets turned into a real drawing, put on a photograph of your entrance, and changed there — where changes are free.

Out here it is as often structural welding as ornament: posts, frames, hinges and rails repaired where they stand rather than carted back to a shop.

Where lots are measured in acres, the gate is often the only structure between the road and the house.

Wind load first, paperwork second

The High-Velocity Hurricane Zone covers Miami-Dade in full, which is what decides the frame and the fixings long before anyone picks a finish. Approval is a separate, local question: in Cutler Bay it runs through whichever authority has jurisdiction, and where a homeowners' association governs the street its architectural review usually runs alongside it.

Custom & Welding — the full breakdown

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of bare cut steel sections clamped on the bench before welding — FabricationBare steel to welded panel

Fabricator welding the finished panel in place on site — FabricationBare steel to welded panel

Worth knowing

On-site welding
Ornamental ironwork
Drawn in-house
Cut and welded here
Solar & battery options

Can you match something that already exists?: Yes — an existing panel, a neighbouring property's detail, or a piece of the house itself.
Structural repair, not a new gate?: We weld on site. Posts, frames, hinges and rails get repaired where they stand.
Can you work from a photograph?: Yes. A photograph of the detail you want matched is usually more useful than a description of it.
Does custom mean a different scale of job?: Not necessarily. Where the opening is an odd width or the pier is not square, a made piece is often the only thing that fits at all.