Can ornamental ironwork be repaired?

Frequently — that is welding and dressing rather than replacement, and it happens on site where the piece is already fixed.

Can a two-leaf gate work on my frontage?

If the setback gives the leaves somewhere to open into, yes — that gets measured on site before anything is drawn.

A pair halves the arc each leaf needs and doubles the hardware. Opening width and setback usually settle it between them.

Is the paperwork the same as Miami?

No. Palm Beach is outside the High-Velocity Hurricane Zone, so it is a different product-approval set, and permitting is administered locally on top of that.

Custom Gate Fabrication in Tequesta, FL

Welder in a hood laying a bead on steel with sparks flying across the bench

Custom fabrication · Tequesta, FL

Drawn properly, then shown on your own entrance before a cut is made.

Get a quote

(954) 245-0182

Grey perforated-panel modern gate across a driveway beneath a cantilevered house overhang. — The north county — From the city up to the Loxahatchee — newer construction, wider frontages, more slide gates than swings.

Tequesta · Palm Beach County

Most custom gates begin as something drawn badly on a phone. That is genuinely enough. It gets turned into a real drawing, put on a photograph of your entrance, and changed there — where changes are free.

Estate frontage is where scrollwork, cast detail and a properly matched pair are worth the shop time, because there is enough opening to actually see them.

Deeper setbacks change the brief entirely: there is room to make an entrance a piece of architecture rather than a barrier.

The coastal towns add a layer

Palm Beach County sits outside the High-Velocity Hurricane Zone, so the product approvals differ from the two counties to the south. On top of that, several towns and associations in this county run design guidelines of their own — so what Tequesta expects is worth reading before a finish is chosen, not after.

Custom & Welding — the full breakdown

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of bare cut steel sections clamped on the bench before welding — FabricationBare steel to welded panel

Fabricator welding the finished panel in place on site — FabricationBare steel to welded panel

Custom & Welding · Tequesta

05 frames

Torch cutting through steel box section on a bench with sparks pouring off

Cutting the sections

Angle grinder throwing a fan of sparks off a steel edge — Dressing the edge

Welding arc flaring as a bead is laid on a steel frame in a dark shop — The arc

Fabricator welding an aluminum picket fence panel in place on site — Welded on site

Sparks falling in front of a metal fence panel being worked on — Sparks off the panel

Worth knowing

Drawn in-house
Cut and welded here
On-site welding
Ornamental ironwork
Two-leaf openings

Can ornamental ironwork be repaired?: Frequently — that is welding and dressing rather than replacement, and it happens on site where the piece is already fixed.
Can a two-leaf gate work on my frontage?: If the setback gives the leaves somewhere to open into, yes — that gets measured on site before anything is drawn.
Two leaves or one?: A pair halves the arc each leaf needs and doubles the hardware. Opening width and setback usually settle it between them.
Is the paperwork the same as Miami?: No. Palm Beach is outside the High-Velocity Hurricane Zone, so it is a different product-approval set, and permitting is administered locally on top of that.