I have a sketch, not a drawing.

A sketch is enough to start. We draw it properly and show you the gate on your entrance.

Can you match something that already exists?

Yes — an existing panel, a neighbouring property's detail, or a piece of the house itself.

Structural repair, not a new gate?

We weld on site. Posts, frames, hinges and rails get repaired where they stand.

Can you work from a photograph?

Yes. A photograph of the detail you want matched is usually more useful than a description of it.

Custom Gate Fabrication in Deerfield Beach, FL

Tall ornate iron gate with scrollwork between stone pillars and lanterns

Custom fabrication · Deerfield Beach, FL

Drawn properly, then shown on your own entrance before a cut is made.

Get a quote

(954) 245-0182

Aerial view of a coastal residential street, its rear gardens enclosed by hedging and fencing. — The coastal strip — The barrier island and the streets immediately behind it, from the county line up to the Hillsboro Inlet.

Deerfield Beach · Broward County

Most custom gates begin as something drawn badly on a phone. That is genuinely enough. It gets turned into a real drawing, put on a photograph of your entrance, and changed there — where changes are free.

Ornamental work this close to the water is a materials conversation first. What gets drawn has to survive the exposure, which rules some sections and some finishes out before the design starts.

Everything within a few blocks of open water runs on the same clock: salt reaches fixings, hinges and enclosures whether or not the house faces the ocean.

Ask before the steel is ordered

Broward is inside the High-Velocity Hurricane Zone, so the wind rating is settled by code rather than by preference. What is not settled by code is the local review — Deerfield Beach handles that itself, and starting it early is the cheapest decision on the whole project.

Custom & Welding — the full breakdown

Custom & Welding · Deerfield Beach

05 frames

Angle grinder throwing a fan of sparks off a steel edge

Dressing the edge

Welding arc flaring as a bead is laid on a steel frame in a dark shop — The arc

Fabricator welding an aluminum picket fence panel in place on site — Welded on site

Sparks falling in front of a metal fence panel being worked on — Sparks off the panel

Gilded heraldic crest mounted on an ornamental iron gate — Crest, gilded

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of bare cut steel sections clamped on the bench before welding — FabricationBare steel to welded panel

Fabricator welding the finished panel in place on site — FabricationBare steel to welded panel

Worth knowing

Ornamental ironwork
Drawn in-house
Cut and welded here
On-site welding
Specified for salt exposure

I have a sketch, not a drawing.: A sketch is enough to start. We draw it properly and show you the gate on your entrance.
Can you match something that already exists?: Yes — an existing panel, a neighbouring property's detail, or a piece of the house itself.
Structural repair, not a new gate?: We weld on site. Posts, frames, hinges and rails get repaired where they stand.
Can you work from a photograph?: Yes. A photograph of the detail you want matched is usually more useful than a description of it.

Nearby

The towns marked The coastal strip share the same geography as Deerfield Beach.