I have a sketch, not a drawing.

A sketch is enough to start. We draw it properly and show you the gate on your entrance.

Can you match something that already exists?

Yes — an existing panel, a neighbouring property's detail, or a piece of the house itself.

Structural repair, not a new gate?

We weld on site. Posts, frames, hinges and rails get repaired where they stand.

Can you work from a photograph?

Yes. A photograph of the detail you want matched is usually more useful than a description of it.

Custom Gate Fabrication in Lake Worth, FL

Tall ornate iron gate with scrollwork between stone pillars and lanterns

Custom fabrication · Lake Worth, FL

Drawn properly, then shown on your own entrance before a cut is made.

Get a quote

(954) 245-0182

Black double swing gate open onto a paver driveway lined with clipped hedging. — The south county cities — The densest run of gated communities anywhere in the three counties.

Lake Worth · Palm Beach County

Most custom gates begin as something drawn badly on a phone. That is genuinely enough. It gets turned into a real drawing, put on a photograph of your entrance, and changed there — where changes are free.

Matching something that already exists is most of the work — an existing panel, a neighbouring run, or a detail lifted off the house itself.

Planned communities repeat — the same frontage width, the same setback, and often the same entry problem several hundred times over.

Different county, different approval route

Because Palm Beach is outside the High-Velocity Hurricane Zone, the approvals a Miami-Dade contractor quotes from memory are the wrong ones here. What Lake Worth actually requires is set locally, and where a town or an association runs its own design guidelines those shape the finish as much as the code shapes the frame.

Custom & Welding — the full breakdown

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of bare cut steel sections clamped on the bench before welding — FabricationBare steel to welded panel

Fabricator welding the finished panel in place on site — FabricationBare steel to welded panel

Custom & Welding · Lake Worth

05 frames

Fabricator welding an aluminum picket fence panel in place on site

Welded on site

Sparks falling in front of a metal fence panel being worked on — Sparks off the panel

Gilded heraldic crest mounted on an ornamental iron gate — Crest, gilded

Torch cutting through steel box section on a bench with sparks pouring off — Cutting the sections

Angle grinder throwing a fan of sparks off a steel edge — Dressing the edge

Worth knowing

Ornamental ironwork
Drawn in-house
Cut and welded here
On-site welding
Shared-entry duty cycle

I have a sketch, not a drawing.: A sketch is enough to start. We draw it properly and show you the gate on your entrance.
Can you match something that already exists?: Yes — an existing panel, a neighbouring property's detail, or a piece of the house itself.
Structural repair, not a new gate?: We weld on site. Posts, frames, hinges and rails get repaired where they stand.
Can you work from a photograph?: Yes. A photograph of the detail you want matched is usually more useful than a description of it.