Skip to main content
Black metal driveway gate and matching fence across the entrance of a South Florida property

Steel, aluminum, iron · Cutler Bay, FL

Material and finish get specified for where the gate has to stand.

Solar panel mounted above a white ornamental gate, with the operator box sitting at its foot.
The south corridorDown US-1 toward the agricultural edge, where lots widen again and mains power is not a given.

Cutler Bay · Miami-Dade County

Steel takes ornamental work and welds hard. Aluminum will not rust and suits long runs. Wrought iron is the traditional answer where the detail matters most. Sun and salt are the design brief in South Florida, so the finish is chosen with the same care as the frame.

A gate set well back on a long drive is a different brief — a wider clear opening for a truck and trailer, longer cable runs, and a leaf that has to stay square with no wall to lean on.

Ground that carries trucks, trailers and equipment moves under load, and anything set into it has to tolerate that.

Inside the High-Velocity Hurricane Zone

Miami-Dade sits inside the Florida Building Code's High-Velocity Hurricane Zone, the strictest wind-load regime in the state, so the rating on posts, panels and hardware is not a nice-to-have here. Permits on top of that are issued locally — by the municipality or by the county — so what Cutler Bay wants to see on paper is worth confirming before anything is cut.

Driveway Gates · Cutler Bay

07 frames
Sun setting through the vertical slats of a dark metal gate

Vertical slat, low sun

Black swing gate open onto a paver driveway with a lawn either side
Swing pair on pavers
Black sliding driveway gate beside a stone pillar with palms behind
Slide, single leaf
Horizontal timber slat gate between brick pillars under flowering bougainvillea
Horizontal slat, brick piers
Wide driveway gate and railing photographed at dusk from the street
Dusk, from the street
Lit driveway gate at night with uplit palms behind it
After dark
Ornate arched iron double gate between rendered pillars at an estate entrance
Ornate double swing

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of a plain builder-grade gate shown on the same driveway
The ornate custom estate gate built on that driveway
Concept · sample
DesignBuilder-grade to bespoke

Before you call

  • On-site measure
  • Drawn before it's cut
  • Shop-fabricated
  • Coastal finish
  • Solar & battery options
How far can the control run?
Further than most people expect, but the run length is what decides the cable, the voltage drop, and whether wireless is the better answer.
Do I need a permit for this?
Often, and Miami-Dade is inside the High-Velocity Hurricane Zone, so the wind rating matters too. Permits are issued locally, so we confirm what your authority wants before we start.
What is the HVHZ?
The High-Velocity Hurricane Zone — the Florida Building Code's strictest wind-load region. It covers all of Miami-Dade, which is why the hardware spec here is not the spec further north.
Will it actually fit my driveway?
We measure on site and draw the gate on your entrance before anything is cut.

Next step

Describe the gate and where it is in Cutler Bay, and you will get an answer from someone who works on them rather than a call-centre script.

Call NowGet a Quote