Will it actually fit my driveway?

We measure on site and draw the gate on your entrance before anything is cut.

Swing or slide — which one?

Slope, curb space and where you park decide it. We tell you what the driveway allows.

How does it hold up here?

Salt and sun are the design brief in South Florida, so material and finish are specified for the coast.

Can I see it before it's built?

Yes. It gets drawn onto a photograph of your entrance, and the changes happen there rather than in the shop.

Custom Driveway Gates in Sunrise, FL

Black swing gate open onto a paver driveway with a lawn either side

Steel, aluminum, iron · Sunrise, FL

Material and finish get specified for where the gate has to stand.

Get a quote

(954) 245-0182

Low sun raking through the vertical slats of a dark timber gate at the end of the day. — The western tier — Acreage and horse property against the Everglades boundary — long drives, gates far from the house.

Sunrise · Broward County

Steel takes ornamental work and welds hard. Aluminum will not rust and suits long runs. Wrought iron is the traditional answer where the detail matters most. Sun and salt are the design brief in South Florida, so the finish is chosen with the same care as the frame.

A gate set well back on a long drive is a different brief — a wider clear opening for a truck and trailer, longer cable runs, and a leaf that has to stay square with no wall to lean on.

Ground that carries trucks, trailers and equipment moves under load, and anything set into it has to tolerate that.

Also inside the HVHZ

Broward falls inside the same High-Velocity Hurricane Zone as Miami-Dade, so the wind rating carries across the county line unchanged. What does not carry across is the paperwork: permitting is administered locally, and the sensible order is to ask what Sunrise expects before the steel is ordered rather than after.

Driveway Gates — the full breakdown

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of a plain builder-grade gate shown on the same driveway — DesignBuilder-grade to bespoke

The ornate custom estate gate built on that driveway — DesignBuilder-grade to bespoke

Driveway Gates · Sunrise

06 frames

Lit driveway gate at night with uplit palms behind it

After dark

Ornate arched iron double gate between rendered pillars at an estate entrance — Ornate double swing

Sun setting through the vertical slats of a dark metal gate — Vertical slat, low sun

Black sliding driveway gate beside a stone pillar with palms behind — Slide, single leaf

Horizontal timber slat gate between brick pillars under flowering bougainvillea — Horizontal slat, brick piers

Wide driveway gate and railing photographed at dusk from the street — Dusk, from the street

Before you call

Drawn before it's cut
Shop-fabricated
Coastal finish
On-site measure
Solar & battery options

Will it actually fit my driveway?: We measure on site and draw the gate on your entrance before anything is cut.
Swing or slide — which one?: Slope, curb space and where you park decide it. We tell you what the driveway allows.
How does it hold up here?: Salt and sun are the design brief in South Florida, so material and finish are specified for the coast.
Can I see it before it's built?: Yes. It gets drawn onto a photograph of your entrance, and the changes happen there rather than in the shop.