Will it work with my existing remotes?

Often. Where the frequency matches, what you already carry gets re-programmed rather than replaced.

The operator type decides most of that. Hydraulic, screw-drive and rack-and-pinion units do not sound alike, which is worth knowing before one is fitted.

The gate is nowhere near a power supply.

That is a normal starting point. Solar, battery and trenched runs are all real options, and the site decides between them.

How far can the control run?

Further than most people expect, but the run length is what decides the cable, the voltage drop, and whether wireless is the better answer.

Automatic Gate Installation in Sunrise, FL

Technician sealing a finished underground safety loop cut in a driveway

Automatic gates · Sunrise, FL

Motor, safety sensors, keypad and phone control — wired and commissioned.

Get a quote

(954) 245-0182

Low sun raking through the vertical slats of a dark timber gate at the end of the day. — The western tier — Acreage and horse property against the Everglades boundary — long drives, gates far from the house.

Sunrise · Broward County

An automatic gate is judged on one moment: the approach. If you have to stop, wind a window down and wait, the automation has not really happened. Operator, receiver and detection all get tuned to that one sequence.

Mains power at the road is not a given out here. That single question decides between a trenched run, a solar operator and a battery-backed unit, and it gets asked first.

Where lots are measured in acres, the gate is often the only structure between the road and the house.

One code, many counters

The wind-load requirement in Sunrise is the High-Velocity Hurricane Zone standard that governs the whole of Broward. The review that sits on top of it is local, and in a county this dense with planned communities an association's architectural approval is frequently the longer of the two.

Automatic Gates — the full breakdown

Before / after

Drag it backto how we found it.

Same job, same angle. Nothing staged between the two frames.

Technician marking a driveway beside a concrete saw before the safety loop is cut — Safety loopCut, laid, sealed, gone

Technician sealing the finished underground loop cut in the same restored driveway — Safety loopCut, laid, sealed, gone

Automatic Gates · Sunrise

05 frames

Lit modern house at dusk with vehicles parked under the entrance canopy

Home before you park

Automated swing gate with its operator arm mounted at the base of a stone pillar — Arm on the pillar

Solar panel mounted above a white aluminum gate powering its operator — Solar-powered leaf

Sliding gate between rendered pillars with clipped hedges either side — Slide between hedges

Ram-arm operator fitted to the hinge post of a light aluminum swing gate — Ram arm, swing leaf

Worth knowing

Phone control
Operator sized to weight
Safety sensors
Loop detection
Solar & battery options

Will it work with my existing remotes?: Often. Where the frequency matches, what you already carry gets re-programmed rather than replaced.
How loud is it?: The operator type decides most of that. Hydraulic, screw-drive and rack-and-pinion units do not sound alike, which is worth knowing before one is fitted.
The gate is nowhere near a power supply.: That is a normal starting point. Solar, battery and trenched runs are all real options, and the site decides between them.
How far can the control run?: Further than most people expect, but the run length is what decides the cable, the voltage drop, and whether wireless is the better answer.