Can my existing gate be automated?

Often yes. The frame has to carry the operator, so we check hinges, posts and weight first.

What happens in a power cut?

Every install gets a manual release, and battery or solar backup where the site suits it.

Is it safe around kids and pets?

Photo-eyes and edge sensors stop and reverse the gate. They are commissioned, not just fitted.

Can I still open it by hand?

Every install gets a manual release, and where it goes is part of the job — it has to be findable in the dark.

Gate Automation in Coral Springs, FL

Lit modern house at dusk with vehicles parked under the entrance canopy

Automating what you have · Coral Springs, FL

Often yes — the frame, hinges and posts get checked before anything is quoted.

Get a quote

(954) 245-0182

Timber-and-steel entry gate framed by dense climbing greenery. — The north-west communities — Master-planned since the seventies, which means shared entries far more often than private ones.

Coral Springs · Broward County

A manual gate can usually be automated, but the frame has to be able to carry an operator. Hinge condition, post fixing and the leaf's real weight get checked first, because bolting a motor to a gate that cannot take it just breaks the gate more expensively.

A shared entry runs far more cycles a day than a private driveway, so the operator is sized on traffic as well as on the gate's weight.

A shared entrance belongs to everybody, which makes downtime a governance problem as much as a mechanical one.

Also inside the HVHZ

Broward falls inside the same High-Velocity Hurricane Zone as Miami-Dade, so the wind rating carries across the county line unchanged. What does not carry across is the paperwork: permitting is administered locally, and the sensible order is to ask what Coral Springs expects before the steel is ordered rather than after.

Automatic Gates — the full breakdown

Before / after

Drag it backto how we found it.

Same job, same angle. Nothing staged between the two frames.

Technician marking a driveway beside a concrete saw before the safety loop is cut — Safety loopCut, laid, sealed, gone

Technician sealing the finished underground loop cut in the same restored driveway — Safety loopCut, laid, sealed, gone

Automatic Gates · Coral Springs

05 frames

Solar panel mounted above a white aluminum gate powering its operator

Solar-powered leaf

Sliding gate between rendered pillars with clipped hedges either side — Slide between hedges

Ram-arm operator fitted to the hinge post of a light aluminum swing gate — Ram arm, swing leaf

Technician sealing a finished underground safety loop cut in a driveway — Loop sealed in

Automated swing gate with its operator arm mounted at the base of a stone pillar — Arm on the pillar

Straight answers

Phone control
Operator sized to weight
Safety sensors
Loop detection
Shared-entry duty cycle

Can my existing gate be automated?: Often yes. The frame has to carry the operator, so we check hinges, posts and weight first.
What happens in a power cut?: Every install gets a manual release, and battery or solar backup where the site suits it.
Is it safe around kids and pets?: Photo-eyes and edge sensors stop and reverse the gate. They are commissioned, not just fitted.
Can I still open it by hand?: Every install gets a manual release, and where it goes is part of the job — it has to be findable in the dark.