Will it survive this close to the water?

Salt is the design brief on the coast, so material, fixings and finish are chosen for the exposure rather than for the photograph.

Does the finish need redoing eventually?

Coatings on the water have a working life. Knowing that at the start is better than discovering it, and it is part of what the material choice trades off.

What does the county require?

Broward sits inside the High-Velocity Hurricane Zone, so wind rating is set by code. The permit itself is local, and an HOA architectural review often runs alongside it.

Is Broward the same as Miami-Dade?

For wind load, yes — both counties are inside the High-Velocity Hurricane Zone. For permitting, no: that is administered locally and it is not identical from city to city.

Gate Automation in Fort Lauderdale, FL

Technician sealing a finished underground safety loop cut in a driveway

Automating what you have · Fort Lauderdale, FL

Often yes — the frame, hinges and posts get checked before anything is quoted.

Get a quote

(954) 245-0182

Aerial view of a coastal residential street, its rear gardens enclosed by hedging and fencing. — The coastal strip — The barrier island and the streets immediately behind it, from the county line up to the Hillsboro Inlet.

Fort Lauderdale · Broward County

A manual gate can usually be automated, but the frame has to be able to carry an operator. Hinge condition, post fixing and the leaf's real weight get checked first, because bolting a motor to a gate that cannot take it just breaks the gate more expensively.

Salt reaches the operator long before it shows on the frame. On the addresses nearest the water the enclosure, the hardware and where the control box is mounted matter as much as the motor inside it.

Wind exposure on the water is not only a number in a code table — it is what actually loads a gate leaf, every afternoon.

One code, many counters

The wind-load requirement in Fort Lauderdale is the High-Velocity Hurricane Zone standard that governs the whole of Broward. The review that sits on top of it is local, and in a county this dense with planned communities an association's architectural approval is frequently the longer of the two.

Automatic Gates — the full breakdown

Before / after

Drag it backto how we found it.

Same job, same angle. Nothing staged between the two frames.

Technician marking a driveway beside a concrete saw before the safety loop is cut — Safety loopCut, laid, sealed, gone

Technician sealing the finished underground loop cut in the same restored driveway — Safety loopCut, laid, sealed, gone

Automatic Gates · Fort Lauderdale

05 frames

Automated swing gate with its operator arm mounted at the base of a stone pillar

Arm on the pillar

Solar panel mounted above a white aluminum gate powering its operator — Solar-powered leaf

Sliding gate between rendered pillars with clipped hedges either side — Slide between hedges

Ram-arm operator fitted to the hinge post of a light aluminum swing gate — Ram arm, swing leaf

Lit modern house at dusk with vehicles parked under the entrance canopy — Home before you park

Straight answers

Safety sensors
Loop detection
Phone control
Operator sized to weight
Specified for salt exposure

Will it survive this close to the water?: Salt is the design brief on the coast, so material, fixings and finish are chosen for the exposure rather than for the photograph.
Does the finish need redoing eventually?: Coatings on the water have a working life. Knowing that at the start is better than discovering it, and it is part of what the material choice trades off.
What does the county require?: Broward sits inside the High-Velocity Hurricane Zone, so wind rating is set by code. The permit itself is local, and an HOA architectural review often runs alongside it.
Is Broward the same as Miami-Dade?: For wind load, yes — both counties are inside the High-Velocity Hurricane Zone. For permitting, no: that is administered locally and it is not identical from city to city.