Can I still open it by hand?

Every install gets a manual release, and where it goes is part of the job — it has to be findable in the dark.

Will it work with my existing remotes?

Often. Where the frequency matches, what you already carry gets re-programmed rather than replaced.

The operator type decides most of that. Hydraulic, screw-drive and rack-and-pinion units do not sound alike, which is worth knowing before one is fitted.

The gate is nowhere near a power supply.

That is a normal starting point. Solar, battery and trenched runs are all real options, and the site decides between them.

Automatic Gate Systems in Wellington, FL

Black automated sliding gate with an entry post standing open at a residential driveway

Safety and backup · Wellington, FL

Photo-eyes, edge sensors and a manual release on every install.

Get a quote

(954) 245-0182

Horizontal timber slat gate between stucco piers, under flowering bougainvillea. — Inland & equestrian — West of the turnpike the county turns to paddocks and service roads, and a gate is sized around a truck and trailer.

Wellington · Palm Beach County

Two things separate a commissioned gate from a fitted one. The detection actually stops and reverses the leaf, tested rather than assumed. And there is a manual release you can find in the dark, with battery or solar backup where the site suits it.

Mains power at the road is not a given out here. That single question decides between a trenched run, a solar operator and a battery-backed unit, and it gets asked first.

Ground that carries trucks, trailers and equipment moves under load, and anything set into it has to tolerate that.

Different county, different approval route

Because Palm Beach is outside the High-Velocity Hurricane Zone, the approvals a Miami-Dade contractor quotes from memory are the wrong ones here. What Wellington actually requires is set locally, and where a town or an association runs its own design guidelines those shape the finish as much as the code shapes the frame.

Automatic Gates — the full breakdown

Before / after

Drag it backto how we found it.

Same job, same angle. Nothing staged between the two frames.

Technician marking a driveway beside a concrete saw before the safety loop is cut — Safety loopCut, laid, sealed, gone

Technician sealing the finished underground loop cut in the same restored driveway — Safety loopCut, laid, sealed, gone

Automatic Gates · Wellington

06 frames

Sliding gate between rendered pillars with clipped hedges either side

Slide between hedges

Ram-arm operator fitted to the hinge post of a light aluminum swing gate — Ram arm, swing leaf

Technician sealing a finished underground safety loop cut in a driveway — Loop sealed in

Lit modern house at dusk with vehicles parked under the entrance canopy — Home before you park

Automated swing gate with its operator arm mounted at the base of a stone pillar — Arm on the pillar

Solar panel mounted above a white aluminum gate powering its operator — Solar-powered leaf

Before you call

Operator sized to weight
Safety sensors
Loop detection
Phone control
Solar & battery options

Can I still open it by hand?: Every install gets a manual release, and where it goes is part of the job — it has to be findable in the dark.
Will it work with my existing remotes?: Often. Where the frequency matches, what you already carry gets re-programmed rather than replaced.
How loud is it?: The operator type decides most of that. Hydraulic, screw-drive and rack-and-pinion units do not sound alike, which is worth knowing before one is fitted.
The gate is nowhere near a power supply.: That is a normal starting point. Solar, battery and trenched runs are all real options, and the site decides between them.