Not necessarily. Posts, piers and rendered pillars are three different structures, and the leaf and the ground decide which one is right.

Can a two-leaf gate work on my frontage?

If the setback gives the leaves somewhere to open into, yes — that gets measured on site before anything is drawn.

A pair halves the arc each leaf needs and doubles the hardware. Opening width and setback usually settle it between them.

Do I need a permit for this?

Often, and Miami-Dade is inside the High-Velocity Hurricane Zone, so the wind rating matters too. Permits are issued locally, so we confirm what your authority wants before we start.

Custom Driveway Gates in Coral Gables, FL

Black sliding driveway gate beside a stone pillar with palms behind

Steel, aluminum, iron · Coral Gables, FL

Material and finish get specified for where the gate has to stand.

Get a quote

(954) 245-0182

Technician working at the control post of a tall ornamental iron gate in front of a palm-lined house. — The estate belt — Deeper setbacks and mature canopy south-west of the city — the openings with room for a two-leaf gate.

Coral Gables · Miami-Dade County

Steel takes ornamental work and welds hard. Aluminum will not rust and suits long runs. Wrought iron is the traditional answer where the detail matters most. Sun and salt are the design brief in South Florida, so the finish is chosen with the same care as the frame.

Deeper setbacks are what make a two-leaf ornamental pair worth fabricating at all: there is room for the leaves to open into the property instead of out over the footpath.

Wider frontages tend to favour a slide or a long swing pair, and both want the ground under them prepared properly.

Inside the High-Velocity Hurricane Zone

Miami-Dade sits inside the Florida Building Code's High-Velocity Hurricane Zone, the strictest wind-load regime in the state, so the rating on posts, panels and hardware is not a nice-to-have here. Permits on top of that are issued locally — by the municipality or by the county — so what Coral Gables wants to see on paper is worth confirming before anything is cut.

Driveway Gates — the full breakdown

Driveway Gates · Coral Gables

06 frames

Dusk, from the street

Lit driveway gate at night with uplit palms behind it — After dark

Ornate arched iron double gate between rendered pillars at an estate entrance — Ornate double swing

Sun setting through the vertical slats of a dark metal gate — Vertical slat, low sun

Black swing gate open onto a paver driveway with a lawn either side — Swing pair on pavers

Horizontal timber slat gate between brick pillars under flowering bougainvillea — Horizontal slat, brick piers

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of a plain builder-grade gate shown on the same driveway — DesignBuilder-grade to bespoke

The ornate custom estate gate built on that driveway — DesignBuilder-grade to bespoke

Before you call

On-site measure
Drawn before it's cut
Shop-fabricated
Coastal finish
Two-leaf openings

Do I need pillars?: Not necessarily. Posts, piers and rendered pillars are three different structures, and the leaf and the ground decide which one is right.
Can a two-leaf gate work on my frontage?: If the setback gives the leaves somewhere to open into, yes — that gets measured on site before anything is drawn.
Two leaves or one?: A pair halves the arc each leaf needs and doubles the hardware. Opening width and setback usually settle it between them.
Do I need a permit for this?: Often, and Miami-Dade is inside the High-Velocity Hurricane Zone, so the wind rating matters too. Permits are issued locally, so we confirm what your authority wants before we start.

Same county

The towns marked The estate belt share the same geography as Coral Gables.