Who is responsible for the entry?

Usually the association rather than any one resident, which changes who we talk to and who signs the work off.

What does the county require?

Broward sits inside the High-Velocity Hurricane Zone, so wind rating is set by code. The permit itself is local, and an HOA architectural review often runs alongside it.

Is Broward the same as Miami-Dade?

For wind load, yes — both counties are inside the High-Velocity Hurricane Zone. For permitting, no: that is administered locally and it is not identical from city to city.

Will it actually fit my driveway?

We measure on site and draw the gate on your entrance before anything is cut.

Custom Driveway Gates in Coconut Creek, FL

Sun setting through the vertical slats of a dark metal gate

Steel, aluminum, iron · Coconut Creek, FL

Material and finish get specified for where the gate has to stand.

Get a quote

(954) 245-0182

Driveway Gates · Coconut Creek

06 frames

Ornate arched iron double gate between rendered pillars at an estate entrance

Ornate double swing

Black swing gate open onto a paver driveway with a lawn either side — Swing pair on pavers

Black sliding driveway gate beside a stone pillar with palms behind — Slide, single leaf

Horizontal timber slat gate between brick pillars under flowering bougainvillea — Horizontal slat, brick piers

Wide driveway gate and railing photographed at dusk from the street — Dusk, from the street

Lit driveway gate at night with uplit palms behind it — After dark

Timber-and-steel entry gate framed by dense climbing greenery. — The north-west communities — Master-planned since the seventies, which means shared entries far more often than private ones.

Coconut Creek · Broward County

Steel takes ornamental work and welds hard. Aluminum will not rust and suits long runs. Wrought iron is the traditional answer where the detail matters most. Sun and salt are the design brief in South Florida, so the finish is chosen with the same care as the frame.

Frontages inside a planned community tend to repeat, and where an association governs the street its architectural guidelines usually decide the envelope the gate has to sit inside.

Where an association governs the street, its architectural review usually runs in parallel with the municipal permit rather than after it.

Also inside the HVHZ

Broward falls inside the same High-Velocity Hurricane Zone as Miami-Dade, so the wind rating carries across the county line unchanged. What does not carry across is the paperwork: permitting is administered locally, and the sensible order is to ask what Coconut Creek expects before the steel is ordered rather than after.

Driveway Gates — the full breakdown

Before / after

Drag it backto how we found it.

Drag the divider to see the change. Where a frame is marked Concept it illustrates the starting point rather than photographs it.

Illustration of a plain builder-grade gate shown on the same driveway — DesignBuilder-grade to bespoke

The ornate custom estate gate built on that driveway — DesignBuilder-grade to bespoke

Before you call

Shop-fabricated
Coastal finish
On-site measure
Drawn before it's cut
Shared-entry duty cycle

Who is responsible for the entry?: Usually the association rather than any one resident, which changes who we talk to and who signs the work off.
What does the county require?: Broward sits inside the High-Velocity Hurricane Zone, so wind rating is set by code. The permit itself is local, and an HOA architectural review often runs alongside it.
Is Broward the same as Miami-Dade?: For wind load, yes — both counties are inside the High-Velocity Hurricane Zone. For permitting, no: that is administered locally and it is not identical from city to city.
Will it actually fit my driveway?: We measure on site and draw the gate on your entrance before anything is cut.