Skip to main content
Close view of cast spear-top finials on a black ornamental iron fence

Set to the grade · Miami Gardens, FL

Panels racked or stepped to the ground so the run stays deliberate.

Black automatic swing gate standing open across a residential driveway, palms and a low stucco house behind it.
North DadeThe band between the county line and the airport — mid-century driveways, newer builds behind them.

Miami Gardens · Miami-Dade County

Ground is rarely level and a fence set as if it were shows it immediately. Panels are either racked to follow the slope or stepped in clean increments — both are decisions, and the wrong one is visible from the road.

Fencing inside a planned community usually has to meet a line that already exists, so the detail comes off the neighbouring run rather than out of a catalog.

Where an association governs the street, its architectural review usually runs in parallel with the municipal permit rather than after it.

Two approvals, not one

Anything structural at the property line in Miami-Dade answers to the High-Velocity Hurricane Zone standard, and that is what sets the frame and the fixings. Separately, Miami Gardens runs a local review, and where a homeowners' association governs the street it generally runs one of its own. Neither is a thing to discover after fabrication.

Fencing · Miami Gardens

05 frames
Ornamental iron fence running behind a clipped hedge under a line of palms

Iron behind hedge · concept scene

Timber-look horizontal slat fence running along a path with planting behindConcept
Horizontal timber-look
Black slat gate set into a wall of climbing greenery at a modern entrance
Slat into greenery
Black horizontal louvre slats silhouetted against water at sunset
Louvre, backlit
Aluminum picket fence running along a planted boundaryConcept
Aluminum picket run

Before you call

  • Aluminum or steel
  • Ornamental estate
  • Set to the grade
  • Matched to the gate
  • Shared-entry duty cycle
Will it match the gate?
The fence is drawn from the same detail as the gate, so the picket, the rail and the finish line up.
Aluminum or steel?
Aluminum will not rust and suits long boundary runs. Steel takes ornamental work. The site usually decides.
My ground is not level.
Panels are racked or stepped to the grade so the top line stays deliberate instead of wandering.
Can you match a fence that is already there?
Usually. Picket profile, rail height and spacing get measured off the existing run rather than guessed from a photograph.

Next step

Nothing is quoted off a photograph alone. The opening gets measured first, and the drawing follows from the measurements.

Call NowGet a Quote